replace PHE Gasket for Funke FP05

Gasketed Plate Heat Exchanger, Plate Heat Exchanger, Plate Heat Exchangers replace Phe Gasket For Funke FP05

PHE plates/gaskets are non-OEM, 100% compatible with genuine parts.

All PHE Gaskets and Plates are produced under approved production conditions, and both Rubber compounds and Plate material are analyzed on a third-party lab. Entrance material-control for Plates and gaskets is made at our own lab, to ensure compliance with certificates.

(Comparison between plate heat exchangers and shell and tube heat exchangers)

a. High Heat transfer coefficient;

Because different corrugated plates invert each other to form a complex flow channel, which makes the fluid flow in the flow channel between corrugated plates in a rotating three-dimensional manner, and can generate turbulence at a low Reynolds number (generally Re=50~200), the Heat transfer coefficient is high, which is generally considered to be 3~5 times that of the shell and tube type. [2]

b. The Logarithmic mean temperature difference is large and the terminal temperature difference is small.

In the shell and tube heat exchanger, two kinds of fluids flow in the tube side and shell side respectively, which is cross flow in general, and the Logarithmic mean temperature difference correction coefficient is small, while the plate heat exchanger is mostly parallel flow or countercurrent flow, and its correction coefficient is usually about 0.95. In addition, the flow of cold and hot fluids in the plate heat exchanger is parallel to the heat exchange surface, without bypass flow, so that the temperature difference at the end of the plate heat exchanger is small, and the heat exchange for water can be less than 1 ℃, And shell and tube heat exchangers are generally 5 ℃