replace PHE Gasket for Funke FP14

Gasketed Plate Heat Exchanger, Plate Heat Exchanger, Plate Heat Exchangers replace PHE  Gasket for Funke FP14

PHE plates/gaskets are non-OEM, 100% compatible with genuine parts.

All PHE Gaskets and Plates are produced under approved production conditions, and both Rubber compounds and Plate material are analyzed on a third-party lab. Entrance material-control for Plates and gaskets is made at our own lab, to ensure compliance with certificates.

1. Small capacity;

Approximately 10-20% of the shell and tube heat exchanger.

2. Large pressure loss per unit length;

Due to the small gap between the heat transfer surfaces and the concavity and convexity on the heat transfer surface, the pressure loss is greater than that of traditional smooth pipes.

3. Not prone to scaling;

Due to sufficient turbulence inside, it is not easy to scale, and its scaling coefficient is only 1/3-1/10 of that of shell and tube heat exchangers

4. Work pressure should not be too high, as leakage may occur;

The plate heat exchanger is sealed with a sealing gasket, and the working pressure should generally not exceed 2.5MPa. The medium temperature should be below 250 ℃, otherwise there may be leakage.

5. Easy to block;

Due to the narrow channels between the plates, usually only 2-5mm, when the heat exchange medium contains large particles or fibrous substances, it is easy to block the channels between the plates. three thousand three hundred and thirty-three