replace phe gasket Vicarb Thermaline V4

Gasketed Plate Heat Exchanger, Plate Heat Exchanger, Plate Heat Exchangers replace PHE Gasket Vicarb Thermaline V4

PHE plates/gaskets are non-OEM, 100% compatible with genuine parts.

All PHE Gaskets and Plates are produced under approved production conditions, and both Rubber compounds and Plate material are analyzed on a third-party lab. Entrance material-control for Plates and gaskets is made at our own lab, to ensure compliance with certificates.

The maintenance of heat exchanger rubber strips mainly involves cleaning, replacement, and maintenance. The following are the specific operating steps: 1. To clean, first use a tool to remove the adhesive strip, then use a cleaning agent to clean the surface of the adhesive strip, and then use clean water to clean the cleaning agent. During the cleaning process, it is necessary to be careful not to use too much force to avoid damaging the adhesive strip. 2. If obvious damage or aging is found on the adhesive strip, it needs to be replaced in a timely manner. The specific operating steps are as follows: (1) Remove the adhesive strip and clean it thoroughly. (2) Drain the liquid from the heat exchanger. (3) Use a tool to remove the original adhesive strip, and then place the new adhesive strip on the heat exchanger to ensure that it is installed in place. (4) Refill the liquid, start the heat exchanger and check whether it operates normally. 3. Maintenance In order to maintain the lifespan and performance of the adhesive strip, regular maintenance is required. The specific operating steps are as follows: (1) If any corrosion, burst or other conditions are found on the surface of the adhesive strip, it should be cleaned or replaced in a timely manner. (2) Regularly apply grease or lubricant to maintain the elasticity and durability of the adhesive strip. (3) Regularly check the pressure and sealing of the adhesive strip, and if abnormal situations are found, they should be dealt with immediately. Overall, the maintenance of the heat exchanger rubber strip is quite important and requires regular cleaning, replacement, and maintenance to ensure its normal operation and service life. At the same time, in order to avoid damage to the adhesive strip or safety accidents caused by improper operation, it is necessary to comply with corresponding operating procedures and safety regulations for safe operation.