replace high quality Alfa laval phe gasket M20

Gasketed Plate Heat Exchanger, Plate Heat Exchanger, Plate Heat Exchangers PHE plates/gaskets are non-OEM, 100% compatible with genuine parts.

All PHE Gaskets and Plates are produced under approved production conditions, and both Rubber compounds and Plate material are analyzed on a third-party lab. Entrance material-control for Plates and gaskets is made at our own lab, to ensure compliance with certificates.

herefore, when the sealing gasket of the plate heat exchanger encounters problems such as leakage, aging, fracture, hardening, etc., it is necessary to use the correct method to replace it in a timely manner. If the operation is improper, it is likely to cause problems such as heat exchanger leakage and liquid leakage.



The following editor will provide a detailed introduction to the replacement sequence and precautions for the sealing gasket of the plate heat exchanger:



1. Replacement sequence



(1) Remove the old gasket. Be careful not to scratch the gasket groove during disassembly.



(2) Use acetone, butanone, or other ketone solvents to remove residual adhesive from the gasket groove.



(3) Wipe the gasket groove and gasket clean with a clean cloth or cotton yarn.



(4) Apply the adhesive evenly to the gasket groove.



(5) Apply clean new gaskets to the plate.



(6) The plates with gaskets should be placed in a flat, cool, and ventilated place and dried naturally before installation and use.