replace PHE Spare Gasket for Reheat UFX42

Gasketed Plate Heat Exchanger, Plate Heat Exchanger, Plate Heat Exchangers PHE plates/gaskets are non-OEM, 100% compatible with genuine parts.

All PHE Gaskets and Plates are produced under approved production conditions, and both Rubber compounds and Plate material are analyzed on a third-party lab. Entrance material-control for Plates and gaskets is made at our own lab, to ensure compliance with certificates.

Regularly check the effectiveness of the cleaning agent during the cycle, which can be measured using a pH test paper. If the solution is maintained at a pH value of 2-3, then the cleaning agent is still effective. If the pH value of the cleaning agent reaches 5-6, an appropriate amount of cleaning agent needs to be added. The pH value of the final solution remained unchanged for 30 minutes at 2-3, indicating that the cleaning effect was achieved. Attention: Cleaning agents can be recycled and reused, and discharge can cause waste.

After reaching the cleaning time, recycle the cleaning solution. Rinse the exchanger repeatedly with clean water until it is completely neutral, and measure the pH value of 6-7 using a pH test paper.

After completing the cleaning, the machine can be turned on and running. You can also perform a pressure test to see if there are any leaks. If there is a leak, polymer composite materials can be used for repair and protection, and can greatly extend the service life of the equipment.

After the equipment stabilizes, record the current medium flow rate, working pressure, heat exchange efficiency, etc